Fluted Tambour Wall Panels

Each box contains four panels. These panels will join next to each seamlessly with a tongue and groove style system.

We have designed the panels to join both width-ways and long ways seamlessly so any length or width can easily be achieved.

Transform your space with our easy-to-install tambour wall panels. Here's a simple step-by-step guide to help you achieve a flawless installation.

Step 1: Preparation
Ensure that the area where you plan to install the tambour panel is clean, dry, and free from obstructions.

Step 2: Gather Necessary Materials
You will need a strong adhesive glue for the installation. Optionally, a nail gun can be used for additional reinforcement.

Step 3: Glue Application
Apply an even layer of the adhesive glue on the back of the tambour panel. Make sure the edges and corners are well covered for optimal adhesion.

Step 4: Positioning the Panel
Carefully place the panel onto the desired spot, pressing firmly to make sure the glued surface makes full contact with the wall.

Step 5: Optional - Nail Gun Reinforcement
For extra security, you may use a nail gun to affix the panel onto the wall. This step is optional and depends on the type of wall and your preference.

Step 6: Clean Up
Immediately after installation, clean any excess glue that may have seeped out from the sides of the panel using a damp cloth.

Step 7: Drying Time
Allow ample time for the glue to dry completely. Refer to the adhesive manufacturer's instructions to know the recommended drying time.

Step 8: Repeat for Remaining Panels
Follow the same process for each panel, ensuring a proper alignment between panels for a seamless finish.

The panels are all in stock, so delivery takes 5-10 days. If we do have to wait for a new production run then it can be 2-3 weeks but please get in contact at the point of order, and we can confirm this right away.

We do not currently offer the panels in custom sizes; however, we have designed them to be easily cut if you need smaller. They also join together seamlessly if you need bigger.

The panels will be absolutely fine in these areas as long as they are not in direct contact of water.

The fluted tambour wall panel range is designed for indoor use only.

It is straightforward to adjust the panels to fit around any object. You can cut the slats with a saw to then apply around any item you may have on your surface.

You can mount the panels on all flat surfaces including brick, concrete and plasterboard.

If installing with batons, then you can use mineral wool or other sound insulation material in-between the gaps which will increase the sound properties.

You can return unused panels within 30 days after delivery.